Price: ₹1,280 - ₹1,080.00
(as of Nov 04,2023 04:37:54 UTC – Details)
3-Foot FT232RL FTDI USB to TTL serial adapter cable for 3.3V logic level serial communication
It is built with FTDI FT232 chip, FTDI’s royalty-free VCP allow for communication as a standard COM port and D2XX ‘direct’ drivers provide DLL application programming interface; a great conversion data cord to meet with your needs of debugging, boot-loading, programming, etc.
NOTE: If any installation or usage issues, please email us or you may download a driver and usage guide on FTDI official website
The original FTDI chip is embedded in the USB-A end; 6 way 0.1” header connector with VCC (5V power) and GND (ground), as well as RXD, TXD, RTS and CTS at 3V logic level.
Applications:
Upgrading Legacy Peripherals to USB
Interface Microcontroller UART or I/O, FPGA / PLD to USB
Replace MAX232 type level shifters allowing for direct connection of products to PC
Industrial Control / USB Software / Hardware Encryption Dongles
Features
– The I/O pins of the FTDI wire are configured to operate at 3V3 logic level – Entire USB protocol handled by the electronics in the cable;
– UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity;
– Data transfer rates from 300 to 3M baud rate at TTL levels;
– Fully assisted hardware (RTS#/CTS#) or X-On / X-Off software handshaking;
– Internal EEPROM with users writable area; – Supply voltage comes from USB bus, no external supply required;
– UHCI / OHCI / EHCI host controller compatible
Specific Interfaces: USB 2.0 type A Male Port ; 6 pin Female Socket Header
Supports Windows 2008, XP and XP 64-bit, Vista and XP 64-bit, CE 4.2, 5.0 and 6.0; Windows 7, 8, 8.1, 10 (32 and 64-bit); Mac OS 8/9 , OS-X; Linux 2.4 and greater
What’s Included
1 x USB to Serial TTL Level Converter Cable
1 x User Manual
A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates
3 feet FTDI USB to serial cable (6 way outputs) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND (power line provides 5V and data signal is at 3.3V)
FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM
Compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater; ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set top box, transmitter, flash firmware on hard drive, etc.
